Page 1 of 1

compatible with ProSim AR 737

Posted: Fri Jan 04, 2019 9:17 pm
by Pilot737
Hi there,

does anybody know, if fs force is supported in all its functions (incl. AP follow) by ProSim. E.g. can fs force read out the ProSim parameters?

Thanks in advance.

Tobi

Re: compatible with ProSim AR 737

Posted: Sat Jan 05, 2019 1:09 am
by RussDirks
I don't know much about ProSim. FS Force is only compatible with FSX and P3D. Is ProSim an add-on for either of these sims, or is it a completely separate sim?

Re: compatible with ProSim AR 737

Posted: Sat Jan 05, 2019 2:01 am
by Pilot737
hi,

its an addon avionic suite for p3d v4 including a seperate flight model (like an addon airplane).

thx for your quick answer.

regards from Germany

Tobi

Re: compatible with ProSim AR 737

Posted: Sat Jan 05, 2019 3:14 am
by RussDirks
Since I don't have that add-on, you'll have to download the demo version of FS Force to see if it is compatible, unless someone else can chime in on that. FS Force might not be able to detect when you activate the AP, depending on how compatible their AP is with the default AP. If that is the case, you will need to use the Manual AP Follow technique.

Re: compatible with ProSim AR 737

Posted: Sat Jan 05, 2019 4:42 am
by Pilot737
Thanks a lot. I will have to try it as there are some other aspects in my setup to be taken into account like my motorized throttle quadrant with motorized trim wheel and indicator. I am curious how this all will interact.
I will let you know as soon as I will start with my FFB 737 yoke project.

Regards Tobi