Cannot have FSForce working for 1 airdraft

Discussions and general chat

Moderator: RussDirks

Post Reply
Emile
Posts: 46
Joined: Sat Nov 01, 2003 2:40 pm
Location: Brussels Belgium
Contact:

Cannot have FSForce working for 1 airdraft

Post by Emile » Wed Mar 21, 2007 2:56 am

Hello,
I cannot have a valid FSForce active for 1 aircraft
Image
I added the requested lines in the panel but without success.
Image
What information do I need to provide to help solving this issue? :oops:
Thanks in advance.
Emile
EBBR
Brussels

RussDirks
Site Admin
Posts: 696
Joined: Sat Sep 13, 2003 1:18 pm
Location: Chilliwack, Canada

Post by RussDirks » Wed Mar 21, 2007 5:56 am

Do you get any force feedback when you fly that plane? The message about the trim gauge is probably because that airplane has a non-standard panel and FS Force can't install the gauge.
Russel Dirks
Forum Moderator

dbrucem
Posts: 6
Joined: Tue Feb 06, 2007 9:07 pm

Post by dbrucem » Sat Mar 31, 2007 6:16 pm

I have had the same issue with Aerosoft's BeaverX. The trim gauge is not enabled but the force feedback works just fine. I just set my trim for takeoff using the aircraft's trim idicator. Once in flight you really don't need the indicator as you just trim to remove control pressures. I also tried manually editing the panel.cfg and Kirk took a shot at it too but no joy. If you figure out afix please post it here. Good luck.
Bruce

Post Reply