Page 1 of 1

3D Printed Force Feedback Yoke

Posted: Thu Jul 20, 2017 5:15 pm
by Jay 3D
Hey guys

I wanted to share my little project here since it's heavily dependent on FS Force. Russ I know this subject is already on the wish list but how much programming time we talking about adapting FS Force to Aerofly FS2? Also are you planing to implement Prop Wash effect at some point?
Otherwise great work mate;)

https://www.youtube.com/watch?v=NqdmvQMBWLo

Jay

Re: 3D Printed Force Feedback Yoke

Posted: Thu Jul 20, 2017 10:39 pm
by RussDirks
Very impressive! Hopefully that will motivate more people to build their own yoke.